Synthetic AW Series
Antiwear Hydraulic Oils

Click on Graph to Enlarge

AMSOIL Synthetic AW Series Antiwear Hydraulic Oils incorporate the highest quality shear-stble, synthetic fluids and are fortified with a premium, zinc-based antiwear hydraulic additive system for maximum protection in low- and high-pressure gear, vane and piston pumps.

AMSOIL Synthetic AW Series Antiwear Hydraulic Oils typically eliminate deficiencies common to other hydraulic lubricants: specifically, thermal and oxidative degradation (which causes varnish and sludge formation), oil and water emulsions (which can lead to rust and excessive wear), lubricant degradation and weight loss (due to hydrolytic instability or high-temperature vaporization).

Performance Features Proven field performance Outstanding thermal and oxidative stability Excellent vane, gear and piston pump protection Excellent low-temperature performance Low copper activity Superior hydrolytic stability Rust and oxidation inhibited Excellent demulsibility Superior antiwear protection Outstanding viscosity/temperature properties Anti-foam formula Extremely high film strength

The synthetic base fluids ensure problem-free operation with service intervals up to 10 times longer than possible with mineral oil-based lubricants. Studies indicate that synthetic lubricants can reduce energy consumption by as much as 10 percent, while providing clean, problem-free operations, extended oil drain intervals and increased uptime. This performance increases efficiency and savings on energy, repair and maintenance costs.

Applications or Requirements Denison HF=0, HF-1 and HF-2 Vickers M-2950-S and I-286-S Cincinati Milacron P-68, P-69 and P-70 U.S. Steel 127 and 136 Racine, variable volume vane pumps DIN 51524, Part 2 AFNOR E 48-603 Ford M-6C32 GM LH-01-1, LH-06-1 and LH-15-1 Lee Norse 100-1 Jeffrey No. 87 BF Goodrich 0152 Commercial Hydraulics * *Except for PM-500 series silver containing pumps which require R&O additive systems.

AMSOIL Synthetic AW Series Antiwear Hydraulic Oils are the primary recommendation for most high- and low-pressure gear, vane and piston industrial and mobile hydraulic applications. AMSOIL Synthetic AW Series Antiwear Hydraulic Oils are preferred for severe duty applications and sealed-for-life systems where optimum performance is required. The ability of AMSOIL Synthetic AW Series Antiwear Hydraulic Oils to dramatically extend drain intervals is subject ot operating environments and maintenance practices and should be monitored by oil analysis.

NOTE: for PM-500 Series silver-containing pump systems, use AMSOIL Synthetic RC Series Gear & Bearing Lubricants.

Although AMSOIL lubricants are compatible with mineral oil-based lubricants, for optimum performance it is recommended that the system be thoroughly drained and cleaned, if warranted.

AMSOIL Industrial Lubricants are formulated to meet or exceed accepted industry specifications. AMSOIL warrants that the use of its lubricants will not cause mechanical damage to any mechanically sound equipment when AMSOIL products are used in full compliance with the company's recommendations. However, the purchaser of these lubricants is responsible for determining if these specifications are adequate and proper for the intended application. The AMSOIL warranty is limited to lubricant performance consistent with indicated specifications. No additional warranty, expressed or implied, can be made.